Water softener how long to regenerate

Water softener regeneration cycle time is about two hours. It is not recommended to use water during a water softener regeneration, as hard water will fill the water heater, which could lead to buildup in the equipment. This eliminates the need for a manual regeneration of your water softener.

Instead of calculating how often your water softener should regenerate, you can set it and forget, enjoying predictably soft water on a daily basis.

Resin beads in the tank attract and hold onto hard water minerals, removing them from the water. Softened water exits the tank and flows to the plumbing throughout your home. The Chemistry of Regeneration During the softening cycle, sodium on the resin beads is exchanged for hard water minerals in the water. A lot happens during this process. Some customers express concern about this process potentially being wasteful.

Overall, though, the benefits of using a water softener far outweigh any potential downsides. Yes, the systems use a lot of water during regeneration — but they also save you water on things like laundry and washing dishes. Fairly quickly after installing a water softener, you should develop an understanding of its regeneration schedule. For one, if your softener regenerates based on demand, your water usage may have changed.

If it regenerates on a time-based schedule, you may have accidentally adjusted the settings at some point. In the latter case, refer to the manual for information on how to reset the schedule. Another common cause is an empty brine tank. You may have forgotten to refill the tank with salt pellets at some point. The salt inside may have also formed a bridge , which disguises how empty the tank really is. Remember, this schedule relies on the salt in your brine tank. If that salt is missing, the process gets disrupted.

If your water softener is stuck in regeneration, it may be caused by a clogged connection. Other potential causes include low water pressure in your home or blockages elsewhere in the system. When hard water passes through your water softener, ions of calcium and magnesium in the water are replaced with sodium ions.

This process takes place in the resin bed. For this system to be effective, your water softener needs to cleanse the resin bed of the harsh minerals when it becomes saturated.

The regeneration is the most technical part of the water softener. Once the resin has trapped all the hardness minerals it possibly can, a salt water solution brine needs to flush through the system to clean it out.

The regeneration involves the water softener being flushed for 10 minutes using the block salt that is loaded into the machine. Each cylinder is cleaned one at a time to ensure softened water is provided to your home, uninterrupted. Hard water will never enter your system. The water is used to drive the brine salt solution regenerant through the water softener and then flush it ready for the next service cycle.

The number of litres used for each regeneration is dictated by the design of the water softener, its size, and efficiency. The water softener needs a specific amount of salt to complete the regeneration.